CMD Tool Flashtec

Car, Truck, Tractors, Marine

The CMDFlash tool is a reader/programmer BDM,EOBD K-LINE,EOBD CAN-BUS,EOBD PWM for all the new generation ECUs.
With BDM you need to unplug the ECU from the vehicle, open and connect it to our tool using a connector available on every EDC16,Marelli,Siemens and Delphi ECU.
This Tool can be sold as a plug-in of our Map3d software or stand-alone.
The Software allow you to read/write the Eprom (29bl802 / M58), the internal firmware and the serial e2prom containing the car’s codes.
Checksum correction algoritm is available for all the ECU families, this mean you don’t have to care about checksums calculations .
With our tool is possible to read all the ecu’s eprom, and after a bad map tuning, a system hung or an interrupted write operation
it is always possible to restart the program operation to restore the ECU and start the car.
All the ECU data can be stored in a single file with additional info like brand, model, plague, chassis number, data, note, customer …..
with search facilities and information directly integrated in microsoft windows explorer.

Features

  • BDM Motorola Mpc
  • Bosch MED17 TRICORE BOOT
  • BDM – MPC5xx
  • CAN V2.0B 1Mb/s
  • K line ISO / KWP
  • J1850 PWM
  • Mitsubishi Lancer EVO 5->9
  • Industrial Vehicles 24V
  • Automatic resistor switch-KLine 470 ohm pull-up resistor for VAG EDC16
  • Protection dongle is now inside the black box
  • Old cars protocols ( i.e. EDC15, ME7, etc ) are now included
  • Master/Slave
  • Recovery mode
  • Automatic checksums
  • OBD KLine, CANBUS, DoiP ENET
  • VAG FRF/ODX/SGO flasher
  • BOOT/Bench Interface for all supported processors ST10,C167,RENESAS,TRICORE,TC29x,MPC5777
  • Read and write unencrypted files
  • All accessories included for OBD, boot and bench
  • High current Power supply suitable for BOOT – Bench and BDM
  • One year free subscription

Update CMD BDM Plugin (Frame and probes not included)

New BOOT-MODE BOSCH MEDC17 IROM/XROM